A.M.P.I. Master-8 Manuel d'utilisateur télécharger pdf (Page 2)

mode. Its duration time is 9.5 msec. and its interval is 2 sec.

3. Set channel #2 to the trigger mode.

Press keys: ‘TRIG, 2, ENTER’ (see Section 7)

Nothing happens, this is because Channel #2 is now in the TRIGGER mode, but is waiting to accept

a trigger. You can trigger it in 3 ways:

a) MANUAL TRIGGERING -

Press key: ‘2’.

(‘2’ is the channel number.) Note that each press on ‘2’ delivers the triggered pulse. Press ‘2’ several

times.

b) EXTERNAL TRIGGERING -

Whenever there is an input pulse in the ‘EXT 2’ input it triggers channel #2 (see Section 9).

c) INTERNAL TRIGGERING -

You can internally connect each channel to any number of the other channels (see Section 9).

4. Connect channel #1 internally to channel #2 -

Press keys: ‘CONNECT,1,2,ENTER’ to connected. (see

Section 9).

Each output of channel #1 triggers channel #2.

Notes:

One. You don’t have to worry about the amplitude or polarity of the trigger

source.

Two. The instruction itself is very straightforward (i.e. similar to the way

you would say it: - “CONNECT from #1 to #2, ENTER”).

Three. You can add manual pulses by pressing ‘2’.

5. Set the duration of channel #2 to be 15 msec. -

Press key: DURA,2,15,ENTER,3,ENTER’ (see Section 8)

1 - Introduction

file:///D|/users/benny/master8.htm (2 of 14) [07/04/2002 12:32:07]

1 2 3 4 5 6 7 ... 13 14

Pas de commentaire

A.M.P.I. Master-8 Manuel d'utilisateur Page 2